Satellite TV Fine tuning tips

I'd like to share the tips I found very useful in optimizing a satellite TV set up, it a guide that I've used. Normally you can check the signal strength and quality value on your Satellite TV, satellite receiver has this function for verification. In my receiver remote control it is the button Info, go ahead and check it.

If this is what you're getting :

0 Strength and 0 Quality (all zero!)
First check all connection are in proper, most common in this type of problem is that the coaxial cable from LNB are connected in marked "in from antenna", this should be connected in "in from dish, digital in or LNB in" label. I somewhat experience this on my initial set-up the label on the back of my receiver is in chinese!, good thing there's only two connection for coaxial cable, it was a trial and error for me.
Another factor for this is the RG6 coaxial cable, this could be grounded or with moist in it. Check the cable or replace it if possible.

0-30 Strength and 0 Quality
On these level check for any obstruction on the satellite dish to the satellite.

40-60 Strength and 0 Quality
with these level there might be a minor adjustment to the initial set-up, most common problem for this are that the bolts are not tightened properly, or heavy wind and rain experience or something bump your dish. you should place the dish to its original set up position (if you have markings on the dish), or perform the dish pointing (if you can, well it easy but tiring!) or call someone who knows how to catch a satellite. Once everything is OK make sure to mark the pole and the side of the dish holder for future reference of the angle ang elevation.

40-60 Strength and 30-70 Quality
With these signal only fine-tuning of LNB is needed until you reach an optimum signal quality between 70-100. this is done by twisting the LNB clockwise or counter clockwise depends on the signal you're getting wait for at least 5 minutes to register the signal on your receiver, if it is getting lower twist it on other way (of course you have to loosen the LNB collar first before doing the twist). After optimization do a channel scan or blind scan.

Always check first the signal strength and quality everytime you encounter any problem with the your satellite TV to give you an idea.